Winget Crocker RP1500XD, Инструкция по эксплуатации и частям

Страница: 19 / 122

OPERATING THE MACHINE
Before starting production the following points should checked:-
(1) That there is oil in (a) the Star Drive Gearbox
(b) the Pan Drive Gearbox
(c) the Loader Winch Gearbox (when fitted)
(d) the Air Line lubricator
(2) The Mixing pan should be clear of loose nuts, bolts, spanners etc., as
these will damage the fingers and blades.
(3) Check that the Discharge Door and Discharge Blade are operating
correctly.
(4) Check that the blade clearances are correct and if necessary adjust, in line
with the maintenance instructions.
(5) Check that the limit switches on the loader stop the Loading Hopper in
the required positions at the top and bottom of the runway.
(6) Check that the Water tank is set to the required amount and is filling up
to this level. (See later page for further information on Water Tank
operation).
(7) When Weigh Gear is fitted check that the setting arrangements and
lubrication requirements have been carried out.
(8) If a Flow Meter is fitted check that the pointer is reset to zero and the
strainer is clean and free from debris.
IMPORTANT:
The CUMFLOW is a high performance Mixer.
The following precautions are necessary to obtain the best results and to avoid
damage to the Mixing Star and Drive.
AGGREGATES:
Strict control of graded aggregates must be maintained. Maximum Size 38mm.
Oversize lumps of aggregate or rogue material must be prevented from entering
the Pan.