WinGD W-X82, Руководство по эксплуатации

Страница: 149 / 548

Operation
0610 − 1/A1
Winterthur Gas & Diesel Ltd.
1/ 1
Prepare for Engine Start after a Long Shutdown Period or
an Overhaul
1. General
For an engine that that was shut down after a long period or an overhaul, do the
special procedures in paragraph 2.
Note: If the engine was shut down only for some days, you must do the
procedures given in 0110 − 1 Prepare for Engine Start after a Short
Shutdown Period.
2. Special Procedures
Note: The numbers (e.g. 4.11) refer to items shown in the control
diagram 4003 − 2 .
1) Do a check of the engine control as given in 4003 − 1 , paragraph 4.
2) If bearings or parts of the running gear were replaced or removed (for checks),
do a check of the the lubricating oil supply at the usual oil pressure (see 0250 − 1
Operating Data Sheet).
3) Do a visual check through the open running gear doors to see if there is sufficient
oil flow from all bearing locations.
During the operation period, it is recommended that you monitor the parts for unusual
heat. You monitor the parts as follows:
4) Start and stop the engine for short intervals (see
0210 − 1 Temperature,
paragraph 9).
5) Compare the temperatures of the newest parts with those that were installed
before.
6) Start and stop the engine for longer intervals.
7) Compare the temperature again as given in steps 4) to 6).
Note: For data about running-in new pistons, piston rings and cylinder liners,
see 0410 − 1 , paragraph 1.2.
8) After the servo oil rail (4.11) is drained, make sure that the drain screw (4.82) is
installed and torqued to 200 Nm (see 8016 − 1 , paragraph 5.2 Pressure release
and drain).
9) Make sure that the scavenge air and exhaust gas can flow freely.
10) If the cooling water for the scavenge air cooler was drained, fill and bleed the
system.
11) Make sure that the drains in the exhaust gas manifold and on the exhaust gas
pipe are closed.
12) Make an analysis of the lubricating oil quality after a long shutdown period (some
months), see 0750 − 1 Lubricating Oils.
Special Procedures Before and After Operation
2014