WinGD RT-flex50DF, Руководство по обслуживанию, Страница: 435 / 586

Maintenance
6545 − 1/A1
Winterthur Gas & Diesel Ltd.
3/ 3
CAUTION
Damage Hazard: Do not put
the electric motor on the
floor without an applicable
support because damage to
the impeller can occur.
9) Operate the two manual
ratchets (94016 − 007, Fig. 3 ) to
carefully remove the electric motor (2)
from the casing (3).
10) Operate the two manual
ratchets (94016 − 007) to move the
electric motor to the right.
11) Attach the engine room crane to the
two slings (94567).
Note: When you do step 12 ), hold the
mass of the electric motor (2).
12) Carefully remove the two manual
ratchets (94016 − 007).
13) Use the engine crane to move the
electric motor to an applicable area.
Note: For data about the procedure to
clean the impeller (and to replace
the ball bearing) refer to the
documentation of the auxiliary
blower manufacturer.
3. Installation
1) Attach the two slings (94657) to the electric motor (2) and the engine room crane.
2) Operate the engine room crane to lift the electric motor (2) until you can attach
the manual ratchets (94016 − 007) to the two slings (94567).
3) Attach the manual ratchets (94016 − 007) to the two slings (94567).
Note: When you do step 4 ), hold the mass of the electric motor (2).
4) Carefully remove the engine room crane from the two slings (94567).
5) Operate the two manual ratchets (94016
− 007) to move the electric motor (2) into
the casing (3).
6) Attach the electric motor (2) to the flange with the screws removed before.
7) Connect the electrical connection to the electrical motor (2).
8) Refer to the Operation Manual to operate the auxiliary blower.
9) Make sure that the electric motor (2) operates in the correct direction.
10) Remove all tools and equipment from the work area.
2016
Auxiliary Blower: Maintenance
94657
94658
WCH03034
2
From
94016 − 007
Fig. 3
Crane
3