Wine Guardian 99H0204-20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 35 / 42

35
Pre-Start-Up
Is there any shipping damage?
If so, Where?
Will this damage prevent unit start-up?
Check power supply. Does it agree with unit?
Has the ground wire been connected?
Has the circuit protection been sized and installed
properly?
Are the power wires to the unit sized and installed
properly?
Have compressor hold down bolts been loosened (snubber washers are snug, but not tight)?
Controls
Are thermostat and indoor fan control wiring connections made and checked?
Are all wiring terminals (including main power supply)
tight?
Has crankcase heater been energized for 24 hours?
Indoor Unit
Has water been placed in drain pan to confirm proper drainage?
Piping
Have leaks checks been made at compressor, outdoor and indoor coils, TXVs (Thermostatic
Expansion Valves), Filter Driers, with a leak detector?
Locate, Repair, and Report any leaks.
Have service valves been opened?
Check Voltage L1: L3:
Start-up
After at least 10 minutes running time, record the following measurements
Suction Pressure:
Suction line temperature:
Discharge pressure:
Discharge line temperature:
Entering outdoor unit air temperature:
Leaving outdoor unit air temperature:
Indoor unit enter-air DB (dry bulb) temperature:
Indoor unit leaving-air WB (wet bulb) temperature:
Indoor unit leaving-air DB (dry bulb) temperature:
Indoor unit leaving-air WB (wet bulb) temperature:
Compressor Amps