HOW TO USE THE TABLE STAND
Th e main unit has a removable table stand that supports
it on the fl at surface. Attach table stand to the bottom
of the main unit in the slots provided. Th e main unit
can also be mounted on the wall using the recessed
screw hole. Th e table stand must be removed prior to
wall mounting. Th e remote temperature sensor can be
similarly mounted or placed on a fl at surface.
GETTING STARTED
Aft er batteries are installed, the remote temperature
sensor will transmit temperature readings at 45-second
intervals. Th e remote rain gauge will transmit rainfall
data at 183-second intervals. Th e main unit may take
up to two minutes to receive the initial readings. Upon
successful reception, the rainfall reading (0.00) will
appear on the top line of the main unit’s display and
the remote temperature will appear on the line below.
Th e main unit will automatically update readings at
45-second intervals.
If no signal is received from the remote temperature
sensor within two minutes, dashes [
] will be dis-
played. Press and hold the front panel
DOWN
( ) but-
ton on the main unit for two seconds or until the Rain
symbol starts fl ashing, to initiate a signal search for the
remote rainfall. Press and hold the back panel
DOWN
( ) button on the main unit for two seconds to initiate
a signal search for the remote temperature.
REMOTE AND INDOOR TEMPERATURES
Th e remote temperature information is located on the
middle line of the main unit’s display. Th e indoor tem-
perature with the icon IN is located next to the remote
temperature. Th e wave icon above the remote channel
number indicates the reception status from the remote
temperature sensor. Th ere are three following types of
the reception status that may be displayed:
NOTE: If the indoor or remote temperature goes above
or below operating range stated in specifi cations, the
main unit’s display will show dashes “
”.
AUTO-SCANNING
Press and hold the CHANNEL button on the back of
CHANNEL
CHANNEL
the main unit for 2 seconds—the icon “ ” will appear
on the display’s middle line below the remote tempera-
ture channel number. All 3 remote temperatures will be
displayed one-by-one automatically for 4 seconds each
in the following sequence: Channel 1, Channel 2 and
Channel 3. To exit from scanning mode, press and hold
the CHANNEL button (on the back) for 2 seconds, and
CHANNEL
CHANNEL
the icon “ ” will disappear, returning the main unit to
the default display mode.
Th e Unit is in searching mode
Temperature readings are
securely registered
No signal
15
16
