Wincor Nixdorf TH200, Руководство программиста

Страница: 61 / 106

Programmer’s Guide
TH200
61
[Note in page
mode]
Example:
character size, white/black reverse printing, or 90° rotated character, etc.), except for
upside-down printing mode.

This command develops bar code data in the print buffer, but does not print it. After
processing bar code data, this command moves the print position to the right side dot of the
bar code.

If d is out of the specified range, the printer stops command processing and processes the
following data as normal data. In this case the data buffer position does not change.

If bar code width exceeds the printing area, the printer does not print the bar code

When CODE128 (m = 73) is used, refer to Appendix for the information of the CODE 128
bar code and its code table.

When using the CODE 128 in this printer, take the following points into account for data
transmission:
①
The top of the bar code data string must be code set selection character
(any of CODE A, CODE B or CODE C) which selects
②
Special characters are defined by combining two characters "{" and one
character. The ASCII character "{" is defined by transmitting "{" twice
consecutively.
Transmit data Specific
character
ASCII Hex Decimal
SHIFT {S 7B, 53 123,83
CODE A {A 7B, 41 123, 65
CODE B {B 7B, 42 123, 66
CODE C {C 7B, 43 123, 67
FNC1 {1 7B, 31 123, 49
FNC2 {2 7B, 32 123, 50
FNC3 {3 7B, 33 123, 51
FNC4 {4 7B, 34 123, 52
"{" {{ 7B, 7B 123, 123
Example data for printing "No. 123456"
In this example, the printer first prints "No." using CODE B, then prints the following numbers
using CODE C.
GS k 73 10 123 66 78 111 46 123 67 12 34 56

If the top of the bar code data is not the code set selection character, the printer stops
command processing and ignore the following data.

If combination of "{" and the following character does not apply any special character, the
printer stops command processing and ignore the following data.

If the printer receives characters that cannot be used in the special code set, the printer
stops command processing and ignore the following data.

The printer does not print HRI characters that correspond to the shift characters or code
set selection characters.