Wincor Nixdorf TH200, Руководство программиста

Страница: 43 / 106

Programmer’s Guide
TH200
43
GS FF Feed paper until the next black mark reaches print position
Code:
Description:
Notes:
ASCII GS FF
Hex 1D 0C
Decimal 29 12
Feed paper until the next black mark reaches print position
This command is only valid when the Mark Sensor is enabled and the paper type is set to
marked paper.
Never use normal paper when marked paper is selected, otherwise this command will
cause the printer to feed a certain length of paper.
Similarly, never use marked paper when the paper type is set to normal paper, otherwise
the printer will enter error paper state.
GS ! n Select character size
Code:
Range:
Description:
Notes:
ASCII GS ! n
Hex 1D 21 n
Decimal 29 33 n
0
≤
n
≤
255
(1
≤
vertical number of times
≤
6, 1
≤
horizontal number of times
≤
6)
Selects the character height using bits 0 to 2 and selects the character width using bits 4
to 7, as follows:
Bit Off/On Hex Decimal Function
0-3 Character height selection. See Table 2.
4-7 Character width selection. See Table 1.
Table 1 Table 2
Character Width Selection Character Height Selection
Hex Decimal Width Hex Decimal Height
00 0 1 (normal) 00 0 1 (normal)
10 16 2(double-width) 01 1 2 (double-height)
20 32 3 02 2 3
30 48 4 03 3 4
40 64 5 04 4 5
50 80 6 05 5 6

This command is all characters (alphanumeric and Kanji) effective except for HRI
characters.

If n is outside of the defined range, this command is ignored.

In standard mode, the vertical direction is the paper feed direction, and the horizontal
direction is perpendicular to the paper feed direction. However, when character
orientation changes in 90° clockwise-rotation mode, the relationship between vertical