D- Sub- Jack Po wer Supp lied (COM2*)
The interface connection is a 9-pin D-sub jack for scanner, user or customer
displays without own power suppy.
Make sure that the connector for the customer display is screwed firmly to
the socket to prevent possible malfunctioning. Power is supplied via this
jack.
If COM2 is equipped with a connector, this interface does not carry a
current.
RJ10/RMT Jack (op tio nal)
You connect the remote (RMT) interface of your POS system via a cable to
the RMT interface of the display (BA8X). You use the RMT function by
pushing the ON/OFF button of the display.
The Remote On/Off function (RMT) enables you to wake up a BEETLE
system out of either standby/ hibernation or soft-off mode. It also puts a
running system into standby / hibernation mode. The activated mode is
depending on the settings of the operating system.
USB (Uni ver sal Se ri al Bus)- A
You can connect several USB peripheral devices e.g. scanner or scales to
the USB.
Only connect devices equipped with a shielded cable to the USB-interface.
RJ45 (LAN)
The system can be connected to a network (LAN) from the POS terminal
back panel.
LEDs
left LED
flashs green
With running network connection
(Network cable connection ON, e.g. HUB,
Router) “Up link”
right LED
flashs yellow
during network traffic
SYSTEM UNIT
24