background image

4

OPM-122

REV C

4. CLEANLINESS -

Keep the generator and surrounding area clean.

 

 

A. Remove all grease, ice, snow or materials that create slippery 

 

  conditions around the unit.

 

B. Remove any rags or other materials that could create a 

 

  potential fire hazard.

 

C. Carefully clean up any gas or oil spills before starting the unit.

 

5.SERVICING EQUIPMENT -

All service, including the installation or replacement of service parts, 

should be performed only by a qualified technician.

 

 

A. Use only factory approved repair parts. 

 

B. Do not work on this equipment fatigued.

 

C. Use extreme caution when working on electrical components. 

 

  High output voltages from this equipment can cause serious 

 

  injury or death.

 

D. Installing a generator is not a “do-it-yourself” project. Consult 

 

  a qualified, licensed electrician or contractor. The installation 

 

  must comply with all national, state, and local codes.

CALIFORNIA PROPOSITION 65

WARNING: 

This product contains crude oil, gasoline, 

diesel fuel and other petroleum products, Antifreeze to 

which can expose you to chemicals including toluene 

and benzene, Ethylene glycol (ingested) which are 

known to the State of California to cause cancer, birth defects or other 

reproductive harm and developmental issues. 

For more information go to www.P65Warning.ca.gov.

SAFETY

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

This manual contains important information that should be understood 

and followed before the installation, operation and maintenance of the 

generator. Failure to follow the safety instructions in this manual could 

result in serious injury or death. Keep this manual available for future 

reference.

ANSI SAFETY DEFINITIONS

DANGER:

DANGER indicates an imminently hazardous situation which, if not 

avoided, 

will 

result in death or serious injury. This signal word is to be 

limited to the most extreme situations.

WARNING:

WARNING indicates a potentially hazardous situation which, if not 

avoided, 

could

 result in death or serious injury.

CAUTION:

CAUTION indicates a potentially hazardous situation which, if not 

avoided, 

may

 result in minor or moderate injury. It may be used to alert 

against unsafe practices.

NOTE: CAUTION is also used on the unit labels and in this manual to 

indicate a situation that could result in serious damage or destruction of 

the equipment and possible personal injury.

1. ELECTRIC SHOCK - 

The output voltage present in this equipment can cause a fatal electric 

shock. This equipment must be operated by a responsible person.

 

 

A. Do not allow anyone to operate the generator without proper 

   instruction.

 

B. Guard against electric shock.

 

C. Avoid contact with live terminals or receptacles.

 

D. Use extreme care if operating this unit in rain or snow.

 

E. Use only three-prong grounded plugs and extension cords.

 

F.  Be sure the unit is properly grounded to an external ground rod 

 

  driven into the earth.

2. FIRE HAZARD -

 

 

A. Keep a fire extinguisher nearby  and know its proper use. Fire 

 

  extinguishers rated ABC by NFPA are appropriate.

3. NOISE HAZARD -

Excessive noise is not only tiring, but continual exposure can lead to 

loss of hearing.

 

 

A. Use hearing protection when working around this 

 

  equipment for long periods of time. 

 

B. Keep your neighbors in mind when permanently installing this 

   equipment.

Содержание TB2400/E













Отзывы: