7
60706-229/F
PREPARING THE UNIT
UNPACKING
CAUTION: EQUIPMENT DAMAGE
When you unpack your new generator, be sure to remove
all of the information sheets and manual from the carton.
1. As you receive your unit, it is critical to check it for any
damage. If any damage is noted, it is always easiest to
refuse the shipment and let WINCO take care of the freight
claim. If you sign for the unit, the transfer of the ownership
requires that you file the freight claim
2. Before proceeding with the preparations of your new
generator for operation, take a couple of minutes to ensure
the unit you have received is the correct model and review
the specification pages in this manual to ensure that this
unit meets your job requirements.
CAUTION
These units are shipped with oil. Be sure to check oil levels
before operating. See engine manufacturer’s instruction
manual for recommended oil requirements before initial
starting.
LUBRICATION
Before starting the engine, fill the crankcase to the proper
level with a good quality oil. The recommended grade oil
and quantity of oil required is listed in the engine operator’s
manual and under the service tab in this manual. This unit
was shipped with most of the oil removed.
The engine normally holds 80 ounces (2.5 quarts) of oil.
Since there is some trapped in the engine, when filling the
crankcase the first time, use the dipstick (‘A’ in following
image) to ensure that you do not over fill the crankcase. The
full oil level mark on the dipstick is depicted in the following
image as ‘B’.
Oil is added to the engine by removing the oil cap and
adding oil at this point. After filling the crankcase to the
proper level, be sure you properly tighten the oil fill cap (‘C’).
NOTE:
This engine generator must be on a level surface
before you check or add oil to the system.
The necessity of using the correct oil and keeping the
crankcase full cannot be overemphasized. Engine failures
resulting from inadequate or improper lubricant are
considered abuse and not covered by the generator or
engine manufacturer’s warranty.
OIL RECOMMENDATIONS
Outdoor temperatures determine the proper oil viscosity for
the engines. Winco recommends our 5W-30 fully synthetic
oil to give you excellent protection in cold temperatures
while maintaining excellent performance in warmer
weather.
Содержание PSS20B2W/C
