Chair will not recline:
5.
If chair will NOT recline when left or right recline levers are pulled,
rotate the gas spring clockwise
(A)
half (1/2) of a revolution
(or 180°).
Chair reclines without the use of recline
levers:
6.
If the chair reclines without the use of recline levers, rotate the
gas spring counter-clockwise
(B)
half (1/2) of a revolution (or 180°).
7.
After adjustment, replace Clevis Pin and Bow-Tie Cotter Pin.
8.
Pull the recline lever
(A)
and push back on the chair back
(B)
to
check for proper adjustment. Repeat above steps as needed until
correct release action is achieved. Then
TIGHTEN HEX NUT
(that
you loosened in step 5).
Make sure all bow tie cotter pins are securely
inserted in all clevis pins and that the cables are
attached through slot
(A)
at opposite end of operator.
Failure to securely insert the bow tie cotter pins into the clevis pin could
cause the clevis pins to fall out and result in injury or damage to the chair.
Page 26 of 32
Document No.: 006335
Revision: K
OWNERS OPERATING & MAINTENANCE MANUAL
INVERNESS 24-HOUR TREATMENT RECLINER™
GAS SPRING RELEASE ADJUSTMENT - CONTINUED
5
6
8
