6
Features: EHL-2C
A
lAmp bAR
(Figure 1) Mouting bar for lamp housing.
B
lAmp housING
(Figure 1) Housing for heat lamps
C
poWeR oN/off sWItch
(Figure 1) Turns power on/off.
D
lockING Nut
(Figure 1) Locks the adjustable main bar in
place to keep heat lamps at optimal height.
E
mAIN bAR
(Figure 1) Raises and lowers height of lamp bar.
F
lAmp bAse
(Figure 1) Wide stance for stability. Standard food
trays will fit between base.
G
RubbeR feet
(Figure 1) Prevent slipping of unit.
Figure 1. EHL-2C Features
Figure 2. EHL-2C Dimensions and Height Adjustments
A
C
D
E
F
G
B
4 HEIGHT
ADJUSTMENTS
(Tabletop to base of light)
12"
14" D
18 5/8" W
24"
19"
17"
15"
Preparation
1. Set unit on a flat surface.
2. Install the Main Bar (E) into the Lamp Base (F).
3. Adjust the Main Bar (E) to appropriate height and insert the
Locking Nut (D) to fix the height.
4. Install bulbs with the specified wattage rating as indicated on the
heat lamp.
5. If unit fails to work properly when first operated, call Winco
customer service @ 1-888-946-2682 or 1-973-916-9958
Operation
befoRe opeRAtING uNIt, It should be checked to see thAt
It Is sIttING level.
1. Plug cord into grounded electrical outlet of the correct voltage.
Electrical shock can occur if appliance is not grounded.
2. Place food products in a pan, located directly under the bulbs for
best results.
3. Turn unit off when not in use.
4. To disconnect appliance, turn switch off and remove plug from
power source.
Cleaning
NOTE
Proper maintenance plays an important part in the life span and
functioning of the heat lamp.
1. Unplug the cord and let heat lamp cool before cleaning or moving.
2. This unit can be cleaned with a damp sponge and mild soap.
Rinse with clean water and wipe dry.
3. Do not immerse in water or other liquid.
Do not clean with a water jet.
Rubber feet are
under lamp base