6
WSHR-3017 Strut & Threaded Rod Shear
7.0
Assembly
See Figures 2 and 3.
1. Insert two guide bars (A) through the frame holes. The guide bars are identical; however, they
must be oriented as shown in Figure 2. Tighten the guide bars in place with the small lock knobs
(B).
2. Slide base (C) with stock stop attached onto the bars.
Make end of bars flush with outer surface
of base
to ensure proper scale use, see Figure 2 inset. Install large lock knobs (D) to secure.
3. Slide base (C) onto opposite end of bars as shown. It is not important that the bar be flush on
this end. Secure with knobs (D).
4. Thread the stock rest pivot rod (E) into
the frame, with flat washers (F), lock
washer (G) and nylon lock nut (H).
5. Thread the stock rest support rod (J)
into frame.
6. Install stock rest onto the rods and
secure with flat washer (F) and lock nut
(H).
7. The stock rest should be snug but still
able to rotate freely out of the way.
Figure 2
Figure 3