8
WSHR-3017 Strut & Threaded Rod Shear
To cut threaded rod, loosen wing nut to release
end of threaded rod rest. See Figure 7. Place
threaded rod against the rest, in the curve
which matches the rod diameter. Slide the rod
through the matching slot in the blade.
NOTE: Cutting threaded rod requires the
threaded rod blade set (not provided; see sect.
10.0).
Figure 7
For threaded rod, there are two recommended
positions, as identified on the threaded rod blade
set. See Figure 8.
For 1/4 and 3/8 inch threaded rod, tighten locking
knob completely. For 1/2 and 5/8 inch rod, turn
locking knob slightly counterclockwise till the
debossed reference point on knob aligns with
indicator line on blade.
Figure 8
9.0
User-maintenance
Disconnect from power/
hydraulic source before performing any
cleaning or maintenance of the unit.
Periodically apply a light coat of machine oil to
exposed metal areas, such as rods, to inhibit
rust.
Periodically inspect tightness of knurled
locking knobs which secure blades to frame.
If cutting becomes difficult, remove stationary
die and clear away any shavings from cutting
area, using vacuum or brush. Do not use bare
hands.
Periodically clean and lubricate the cutting die
blade edge with machine tool oil.
9.1
Additional servicing
Any additional servicing should be performed
by authorized service personnel.
