WilTec XPOtool 63444, Руководство по эксплуатации

Страница: 9 / 14

https://www.XPOtool.com Item 63444–63445 Page 9
The Tool Experts
08 2022-1
№ Name
1 Adjusting disc
2 Shaft
3 Impeller
4 Housing cover
5 Volute casing
Troubleshooting
Engine cannot be started
Error Cause Suggested solution
The spark plug
does not ignite
Spark plug Ignition device wet Allow to dry.
Deposit on spark plug Remove deposit.
Spark plug gap too large or too
small Adjust distance to 0.6–
0.7
mm.
Spark plug contacts burnt Replace.
Insulation damaged Replace.
Ignition Wire connection loose or broken Tighten or replace.
Poor insulation of the coil Replace.
Gap between stator and rotor too
large Adjust distance to 0.4 mm.
Error Cause Suggested solution
The spark plug
works normally
Compression ratio OK
and fuel supply normal
Fuel intake too high Reduce fuel.
Quality of fuel poor and mixes
with water and dirt Replace fuel.
Good fuel supply, but
poor compression ratio
Cylinder or piston ring worn
or cracked Replace.
Carburettor does not get
fuel
No fuel in tank Fill with fuel.
Fuel tap not open Open tap.
Air hole of tank blocked Clean.
Engine stops during operation
Error Cause Suggested solution
Engine stops suddenly
Piston seizure Replace or repair piston.
Carbon deposits on spark plug
lead to short circuit Remove carbon deposits.
Poor ignition Check and remedy.
Engine stops slowly
Too little fuel Refill fuel.
Carburettor clogged Clean carburettor.
Water in fuel Replace with fresh fuel.