https://www.XPOtool.com
Item 63444–63445
Page 8
The Tool Experts
08 2022-1
Disassembly and assembly
Attention!
Please do not disassemble the motor under any circumstances. Have disassembly carried
out only by a qualified specialist.
Disassembly
1.
Loosen the screw and remove the handle and the pump
housing one after the other.
Note!
Note the mounting position of the volute casing
in the pump casing
2.
The screw of the impeller turns clockwise, when turned,
the impeller is turned down.
Caution!
Please make sure that you do not lose the possible adjusting washer between impeller and
shaft.
Assembly
1.
When replacing the impeller and volute casing, please adjust the distance to 0.8
mm by adjust-
ing the adjusting washer.
2.
The tightening torque of the screws on the pump is shown in the following list.
Screw
Torque
(Nm)
M5
2.5–3.5
M6
4–6
M7
9–11
M8
9–11
A
B= .
. mm
