Wilson Electronics MAXX 2 Series, Руководство пользователя

Страница: 51 / 83

the red terminal and the black wire to the black terminal.
• Connect the wire exiting the right side of the woofer cabinet to the right side
terminal pair labeled High-Frequency (see Figure 16).
• Attach the main input from the amplifier to the Main Input terminals located
on the bottom module in the rear.
S e c t i o n 5 . 3 – S p i k e I n s t a l l a t i o n
Note: This is a 2-person job. Do not attempt this with only one person. The MAXX
weight is over 400-lbs. and may cause injury if tipped over.
M a t e r i a l s R e q u i r e d
• 8 sets of spikes
• Caster wrench
• 9/16” combination wrench
Installation Procedure:
• Have one person tilt the MAXX
just enough to remove the caster.
• Use the caster wrench to loosen
the casters. Remove the casters
and set them aside.
• Insert the finished spike assembly.
Hand-tighten only!
Note: Be very careful NOT TO CROSS THREAD the spikes. The base of the MAXX is
made of “X” material and is prone to cross threading (see Figure 17).
51
S
E C T I O N
5 - F
I N I S H I N G
U
P
F
I G U R E
1 7 - I
N S TA L L I N G T H E S P I K E S
R
E M O V E
C
A S T E R
I
N S TA L L
S
P I K E