Wilson Electronics MAXX 2 Series, Руководство пользователя

Страница: 33 / 83

S e c t i o n 3 . 1 – I n i t i a l A s s e m b l y
S p i k e A s s e m b l y
• Locate the spike assembly. On the spike, move the nut to about two threads
from the point. This will allow for greater movement when leveling the loud-
speaker system.
• Screw the spikes into the
diode until the nut is against
the diode. Be careful that
the nut does not turn while
inserting and threading
spikes into the diode.
Note: Do not tighten these assembled
spikes. You will need to unscrew them
when you level the MAXXs.
• Place the setscrew into the
other end of the diode with
the Allen head toward the
spike. This will ensure that
if for any reason you have to remove your MAXX spikes, you will be able to
withdraw the setscrew safely using the supplied Allen wrench. Screw the
setscrew into the diode until it meets the spike (see Figure 5).
• Place the assemblies out of the traffic pattern until they are needed during the
installation.
U p p e r M o d u l e A s s e m b l y
The upper module requires only the installation of the front “A” spikes (see Figure 6
on page 34). The spikes screw into the bottom of the upper module as shown in Figure 6
33
S
E C T I O N
3 - A
S S E M B L I N G
Y
O U R
M A X X
F
I G U R E
5 - W
O O F E R
P
AW A S S E M B LY
D
I O D E
S
P I K E A N D
N U T
S
E T S C R E W