7
Need help?
www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
4.
Fit the assembly onto the pole in your
desired location by sliding the second
half of the bracket onto the U-bolt and
securing it with the lock washers and
nuts provided. Be sure the cradle is at
the desired height and rotated toward
the strongest cellular signal before
tightening the nuts.
Do not over tighten.
Rotate in 45°
increments
5.
Connect the supplied coax cable to
the antenna lead cable on the Outside
Antenna.
6.
Route the cable as desired to the
location of the DT4G. If you need to
connect both coax cables, use the Cable
Connector provided. Secure the cable
with ties as needed (ties not provided).
Outside Wall Mount Option
1.
Select a location on an outside wall
as high as possible and at least
20 feet from where the DT4G will
be located. The wall should face in
roughly the same direction as the
strongest cellular signal.
2.
Position the Outside Antenna bracket,
from Packet B, on the wall as a
template and mark the screw holes
with a pencil.
Face in roughly the same
direction as the strongest
cellular signal
3.
Drill four holes where you marked,
using a 3/16-inch bit. Insert the plastic
screw anchors provided in Packet B.
Outside
Antenna
bracket
4.
Line up the Outside Antenna bracket
with the screw anchors. Mount
the cradle antenna bracket to the
wall using the four screws and four
washers provided in Packet B.
wall
side view
anchors
anchors
antenna bracket
5.
Connect the supplied coax cable to
the antenna lead cable on the Outside
Antenna.
6.
Route the cable as desired to the
location of the DT4G. If you need to
connect both coax cables, use the
Cable Connector provided.