English
Installation and operating instructions - Wilo-HiControl 1/FC
19
4 Intended use
Control device for operating and monitoring a pump in domestic water supply. The
device is screwed onto the discharge side of the pump or into the discharge pipe.
It allows fully automatic operation without a diaphragm expansion tank.
5 Product information
5.1 Technical data
Hydraulic data
Fluid
Clear water without solid particles
Maximum flow rate
10 m
³/h
Maximum operating pressure
10 bar
Connection diameter
R1"
Temperature range
Max. fluid temperature
+60 °C
Electrical data
Protection class
IP65
Max. current
16 A
Voltage
Single-phase 220/250 V
Frequency
50/60 Hz
Technical information
Start-up pressure
1.5 bar to 2.7 bar
5.2 Dimensions
Fig. 6: Lateral view – frontal view
5.3 Description of the product
(Fig. 1, 2 and 5)
1 - Suction port with integrated non-return valve
2 - Pressure port
3 - Control pressure gauge (0 – 10 bar),
installation is possible on the right or on the left
4 - Electrical box with circuit board including dry-running protection by deactiva
-
tion of the motor, electrical connection of the pump and mains connection
5 - Hydraulic chamber with membrane
6 - Compensation chamber with spring
7 - Adjusting screw for pump start-up pressure
8 - RESET key
9 - Voltage control lamp
10- Pump operation control lamp
11- Safety system control lamp
12- Pressure gauge axle
