Wilo DrainLift S Series, Инструкция по установке и эксплуатации

Страница: 8 / 28

en Application/use
8 WILO SE 2017-06
▪ Ensure all connections for the inlet, pressure pipe and venting are sealed tightly and in
accordance with regulations!
▪ When opening the collection reservoir (e.g. during maintenance work), ensure appropri-
ate replacement of air!
2.7 Transport ▪ Wear the following protective equipment:
– Safety shoes
– Safety helmet (when using lifting equipment)
▪ Hold the reservoir when transporting the device. Never pull the power supply cable!
▪ Devices weighing 50 kg and over must be transported by two persons. Generally, it is
recommended that two persons transport the device.
▪ If lifting equipment is used, observe the following points:
– Only use legally specified and approved lifting gear.
– Select the lifting gear based on the existing conditions (weather, attachment point,
load, etc.).
– Always attach the lifting gear to the attachment points.
– The stability of the lifting equipment must be ensured during operation.
– When using lifting equipment, a second person must be present to coordinate the
procedure if required (e.g. if the operator’s field of vision is blocked).
– Persons are not permitted to stand beneath suspended loads. Do not carry suspen-
ded loads over workplaces where people are present.
2.8 Installing/dismantling ▪ Wear the following protective equipment:
– Safety shoes
– Safety gloves against cuts
– Safety helmet (when using lifting equipment)
▪ Locally applicable laws and regulations for work safety and accident prevention must be
complied with.
▪ Disconnect the device from the mains and secure it against being switched on again
without authorisation.
▪ Close the gate valve in the inlet and in the pressure pipe.
▪ Provide adequate aeration in closed rooms.
▪ When working in chambers and closed spaces, a second person must be present for
safety reasons.
▪ Take immediate countermeasures if there is a build-up of toxic or suffocating gases!
▪ Clean the device thoroughly both inside and outside.
2.9 During operation ▪ Do not open the device!
▪ Open all gate valves in the inlet and in the pressure pipe!
▪ Ensure ventilation!
▪ The operator is trained in the functionality and the options for switching off the device!
2.10 Maintenance tasks ▪ Wear the following protective equipment:
– Closed safety goggles
– Safety gloves
▪ Close the gate valve in the inlet.
▪ Only carry out maintenance tasks mentioned in these installation and operating in-
structions.
▪ Only original parts from the manufacturer may be used for maintenance and repairs.
Use of parts other than the original parts releases the manufacturer from any liability.
▪ Collect any leakage of pumped fluid immediately and dispose of it according to the loc-
ally applicable guidelines.
2.11 Operator responsibilities
▪ Installation and operating instructions must be in a language which the personnel can
understand.
▪ Make sure that the personnel is relevantly trained for the specified work.
▪ Provide the necessary protective equipment and make sure that the personnel wears it.
▪ Safety and information signs mounted on the device must be always legible.
▪ Train the personnel pertaining to the functioning of the system.
▪ Eliminate risk from electrical current.
Children and persons below 16 years or with reduced physical, sensory or mental capa-
cities or limited experience are prohibited from handling the device! A technician must
supervise persons below 18 years!
3 Application/use