Wilo Control MS-L 2x8A-T4-DOL-X, Инструкция по установке и эксплуатации

Страница: 16 / 40

en Transportation and storage
16 WILO SE 2020-05
Example: Wilo-Control MS-L 2x8A-T4-DOL-X
X
Versions:
without = standard version with main switch
LS = version for lifting unit without main switch, with cable and plug
O = without main switch, without plug (mains isolator to be provided by
the customer!)
4.7 Operation on electronic start-up
controllers
The switchgear must be connected directly to the pump and the mains. Intermediate
switching of additional electronic start-up controllers, e.g. a frequency converter, is not
permitted!
4.8 Installation in potentially explos-
ive atmospheres
The switchgear does not have its own explosion protection class. It may not be installed
in potentially explosive areas.
4.9 Scope of delivery
Standard version and MS-L...-O version
ƒ
Switchgear
ƒ
2x reducing seals for threaded cable gland
ƒ
2x assembled jumper wires for mains connection
ƒ
Rechargeable battery for mains-independent alarm signals
ƒ
Installation and operating instructions
“MS-L...-LS” version for lifting units
ƒ
Switchgear with 1.5 m connection cable and plug:
–
1~230 V: Shockproof plug or CEE32-plug
–
3~400 V: CEE16-plug
ƒ
Rechargeable battery for mains-independent alarm signals
ƒ
Installation and operating instructions
4.10 Accessories
ƒ
Float switch for drainage and sewage
ƒ
Signal lamp
ƒ
Flash light
ƒ
Horn
5 Transportation and storage
5.1 Delivery
After receiving the shipment, check it immediately for defects (damage, completeness).
The transport company or the manufacturer must be notified of any defects the day the
shipment is received, and the damage noted on the freight documentation. Claims can-
not be asserted if the notification of defects takes place at a later date.
5.2 Transport
ƒ
Clean switchgear.
ƒ
Close housing apertures, ensuring they are sealed watertight.
ƒ
Impact-resistant and watertight packaging.
Replace soaked packaging immediately!
CAUTION
Soaked packaging may tear!
The product may fall on the ground if unprotected and may be damaged. Lift wet
packaging carefully and replace it immediately!
5.3 Storage
ƒ
Pack the switchgear in dustproof and watertight packaging.
ƒ
Storage temperature: -30 … +60 °C, max. relative humidity: 50 %, non-condensing.
ƒ
Frost-proof storage at a temperature of 10 … 25 °C with relative humidity of 40 …
50 % is recommended.
ƒ
Avoid the formation of condensation at all times!
ƒ
All open threaded cable glands must be sealed to prevent water ingress into the
housing.
ƒ
Attached cables should be protected against kinking, damage, and ingress of mois-
ture.
ƒ
To prevent damage to the components, protect the switchgear from direct sunlight
and heat.
ƒ
Clean the switchgear after storage.