Wills Wing Fusion 141, Руководство по эксплуатации для владельца

Страница: 18 / 68

— 10 —
b. If the glider is equipped with a non folding basetube:
i. Remove the safety ring, wing nut and bolt from the corner bracket.
ii. Insert the corner bracket all the way into the basetube.
iii. Install the bolt, wingnut and safety, securing the bracket to the basetube.
Make sure that the aluminum fitting is fully inserted into the basetube, and that the bolt is
through both the basetube and the fitting.
If the hole in the fitting can be seen outside the end of
the basetube, the fitting is not fully installed, and will likely disengage in flight resulting in a
dangerous structural collapse and loss of control of the glider.
Do not insert the fitting at an angle, and do not force the fitting into the basetube if it does not slide
in freely. Check for dirt or damage to the fitting or the inside of the basetube. If the fitting is forced
into the basetube, it may be impossible to remove. See your dealer if the fitting becomes difficult to
install or remove.
4. Flip the glider upright on the control bar, and remove the bag and all the velcro ties. Do not remove
the leading edge tip protector bags at this time, but do loosen the velcros on the tip bags. If there is
more than eight m.p.h. of wind, or if the wind is gusty, turn the glider 90 degrees to the wind
direction.
Spread the wings almost all the way.
5. Install the elevated hang system spreader bar onto the base pillar. Check for free pivoting move-
ment of the spreader bar, and that the pivot pin is securely installed in the slot in the base pillar.
Webbing Hang System Perlon Hang System
6. At this time, undo the velcro attachment of the two halves of the front keel pocket. This is to allow
the xbar center wedge and its rear webbing hold down strap to slide freely aft on the keel when you
tension the crossbar.