Williams 2509621, Руководство пользователя

Страница: 22 / 40

Operating Your Furnace
22
FOR YOUR SAFETY, READ BEFORE LIGHTING THE PILOT
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
LIGHTING THE PILOT
A.
This appliance has a pilot which may be lit by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell around the appliance area for gas.
Be sure to smell next to the floor because some gases are
heavier than air and will settle on the floor.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempts to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
E. WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance or strike a match.
• Do not touch any electrical switch; do not use any phone or
cell phone in your building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department
.
OPERATING INSTRUCTIONS
1.
STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. If applicable, turn off all electric power to the appliance.
4. Open control access panel.
5. Push in gas control knob slightly and turn clockwise
to "OFF". (Figure
21).
6. Wait five (5) minutes to clear out any gas, then smell for gas,
including near the floor. If you then smell gas, STOP! Follow
"E" in the safety information above. If you don't smell gas, go
to the next step.
7. Loosen wing nut and open the pilot observation door (if
equipped).
8. To find the pilot, follow metal tube from the gas control. The
pilot is mounted on the side of the burner. (Figure 22).
9. Turn knob on the gas control counterclockwise
to
"PILOT".
10. Push in the control knob all the way and hold in. Immediately
light the pilot. Continue to hold the control knob in for about
one (1) minute after the pilot is lit. Release the knob and the
pilot flame will pop back up. The pilot should remain lit. If it
goes out, repeat Steps 5 through 10.
• If knob does not pop up when released, stop and
immediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas
control knob "OFF” and call your service technician or gas
supplier.
11. Close pilot observation door, tighten wing nut (if equipped).
12. Turn gas control knob counterclockwise to "ON”.
13. Close control access panel.
14. Turn on all electric power to the appliance (if applicable).
15. Set thermostat to desired setting.
IMPORTANT:
KEEP BURNER AND CONTROL COMPARTMENT CLEAN.
FIGURE 21 – Gas Control Knob
FIGURE 22 – Pilot and Generator