Williams Sound SoundPlus WIR SYS 90 ADV, Руководство по установке и Руководство пользователя

Страница: 13 / 16

13
Trouble Shooting
The WIR TX90 “Power On” indicator is not lit.
u
Make sure the transformer is plugged into the transmitter and any remote power switch is on.
u
Make sure the electrical outlet is on.
u
Make sure the 24 VAC power supply is working.
The WIR TX90’s channel A or B “On” indicator is not lit.
u
Make sure the desired audio channel has been activated. See Selecting a Channel on page 7.
u
Make sure the WIR TX90 is plugged in.
u
Make sure the audio input is connected properly. See page 6 or instructions on the back of the
WIR TX90.
u
Make sure an active audio signal is being sent to the WIR TX90 transmitter.
No sound through receivers.
u
Check to make sure the receiver is operating on the same frequency as the transmitter.
u
If some of the receivers work but others don’t, check for bad batteries or earphones on the receivers
that aren’t working.
u
If none of the receivers work, check to see if the power and audio input cable are connected to the
transmitter and that the WIR TX90 “Power On” and Channel A or B “On” indicator is illuminated.
u
Check to see if the transmitter is connected properly to the sound system. The audio level indicators
should flash on channels that are selected.
u
Make sure the “eye” is not covered up on the receiver. There must be clear line of sight between the
receiver eye and the transmitter panel.
Sound through the receivers is weak and noisy.
u Listen to the audio signal through the headphone jack on the WIR TX90 transmitter (Figure 10). If
the signal is weak and noisy here, try increasing the audio input level (see Adjust Audio Input Level,
page 8), or increase the input signal level from the sound system by turning up the mixer control.
If the signal sounds okay, you may need to reposition the transmitter panel or add additional IR
emitters to the TX90 system.
Buzzing or humming noise in sound system.
u
Check for ground loops or noise on the input signal. Call your Authorized Williams Sound dealer or
representative.
NOTE: Make sure the powerline voltage does not fall below 90V, or system performance will be
greatly reduced!