P.
29
Engelsk
P.
29
Engelsk
29
Engelsk
P.
P.
Warning:
If the kettle is overfilled, boiling water may be ejected.
Is the cable damaged, it must be replaced by authorized personnel.
Is there damage to the device or that it does not work, it must be
serviced only by authorized personnel.
Before connecting the kettle, check whether the voltage indicated
on the appliance, is the same as the voltage in your home.
Special Safety Instructions for the Kettle
Use only cold water when filling the device.
The water level must be between the MAX. and MIN. marks.
Switch the kettle off before removing it from the base.
Always ensure that the lid is tightly closed.
The base and exterior of the kettle must not become wet.
Kettle body used must match with the kettle base.
First Use of the Kettle
Before using the kettle for the first time, fill the kettle with cold water
and boiled it twice without any additives.
Fill the kettle with water. Do not overfill. Use the water level indicator.
Place the kettle on the base.
Press the “ ” key shortly, with the sound “Di.”, it starts run-
ning. After the water boils, indicator turns off and the buzzer
sends out a sound “Di” at the same time.
Press “ ”for 3 seconds, with the buzzer sends out “Di”sound,
it starts running the function of heat insulation. The LED light will
be shinning with red light, while after the water boils, the kettle
will keep the water temperature for 2 hours with the indicator light
shinning. During the 2 hours heat insulation function running, it
will go on heating when the temperature arrives at 85°C.
Press “ ”for once, the indicator light of 60°C shines, with the
green LED light. It means that it will stop heating when the water
temperature is 60°C.
Press “ ” for twice, the indicator light of 70°C shines, with the
blue LED light. It means that it will stop heating when the water
temperature is 70°C.
WKD_2200S_IM_Temp_Wilfa.indd 29
06.12.12 12.40
