Wilfa Narvik 25, Инструкция по эксплуатации

Страница: 23 / 154

23
EN
AIR CONDITIONER · NARVIK
4. Under the initial presetting temperature 28°C-30°C, after Sleep function
started up, the temperature will decrease 1°C in every hour, after 3°C
decreased, this temperature will be maintained.
Sleep 3 - the sleep curve setting under Sleep mode by DIY:
1. Under Sleep 3 mode, press “Turbo” button for a long time, remote
controller en-ters into user individuation sleep setting status, at this time,
the time of remote controller will display “1hour”, the setting temperature
“88” will display the corr-esponding temperature of last setting sleep curve
and blink (the first entering will display according to the initial curve setting
value of original factory);
2. Adjust “+” and “-” button, could change the corresponding setting
temperature, after adjusted, press “Turbo” button for confirmation;
3. At this time, 1hour will be automatically increased at the timer postion on
the remote controller, (that are “2hours” or “3hours” or “8hours”), the place
of se-tting temperature “88” will display the corresponding temperature of
last setting sleep curve and blink;
4. Repeat the above step (2)~(3) operation, until 8 hours temperature setting
finished, sleep curve setting finished, at this time, the remote controller will
resume the original timer display; temperature display will resume to original
setting tem-perature.
Sleep 3 - the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting
sleep curve, enter into user individuation sleep setting status, but do not change
the tem-perature, press “Turbo” button directly for confirmation.
Note:
In the above presetting or enquiry procedure, if continuously within10s,
there is no button pressed, the sleep curve setting status will be automatically
quit and resume to display the original displaying. In the presetting or enquiry
procedure, press “ON/OFF” button, “Mode” button, “Timer” button or “Sleep”
button, the sleep curve setting or enquiry status will quit similarly.
Combination of “TEMP” and “CLOCK” buttons:
About Energy - saving Function
Press “TEMP” and “CLOCK” simultaneously in COOL mode to start energy-
saving function. Nixie tube on the remote controller displays “SE”. Repeat the
operation to quit the function.
Combination of “TEMP” and “CLOCK” buttons:
About 8°C Heating Function
Press “TEMP” and “CLOCK” simultaneously in HEAT mode to start 8°C heating
function. Nixie tube on the remote controller displays “ ” and a selected
temperature of “8°C”. Repeat the operation to quit the function.