10
MARBLE ACCESS COVER
CRITICAL DIMENSIONS
This Access Cover MUST be constructed from Non-Combusble Materials.
These diagrams detail the CRITICAL dimensions of the MARBLE/STONE ACCESS COVER
This informa"on is to be used for both
950L STANDARD
&
950L PRECAST
MANTELS
DESCRIPTION
mm
(min)
mm
(max)
A
Marble Access Cover Width
799mm
801mm
B
Marble Access Cover Height
98mm
100mm
C
Chamfer Detail
6mm
N/A
A Marble/Stone Access Cover is required to sit below the front trim plate. This Access Cover is used to conceal
the controls area of the appliance and provides access for ba?ery changes or service.
The installer should check that the Access Cover has been made to the correct dimensions and then ensure the
rear face is dry and clean, mark a ver"cal centre line with a pencil.
Using the two pieces of double sided bonding tape supplied, affix the support plate to the rear face of the Access
Cover.
Ensure that the support plate and the Access Cover are flush at the base and that the two arrow marks are
aligned in the centre of the marble cover (see fig 3 below).
The marble/stone access cover sits on the hearth in front of the appliance.
Use the two adjustable magnets on the appliance to align the front edge of the marble with the mantel.
