WIL-10150-E-12
8
P2 Clamped Plastic
SECTION 5
P2 PLASTIC
RUBBER-FITTED
Ship Weights……...Polypropylene 8 kg (75 lb)
PVDF 10 kg (23 lb)
Air Inlet……………………..……….6 mm (1/4")
Inlet…...…………………...…………25 mm (1")
Outlet………………...………………25 mm (1")
Suction Lift……………………...5.5 m Dry (28')
8.8 m Wet (29')
Disp. per Stroke
1
……...…....0.31 L (0.082 gal)
Max. Flow Rate……………..140 lpm (37 gpm)
Max. Size Solids…………………3.2 mm (1/8")
1
Displacement per stroke was calculated at 4.8
bar (70 psig) air inlet pressure against a 2.1 bar
(30 psig) head pressure.
Example:
To pump 68 lpm (18 gpm)
against a discharge pressure head of
2.7 bar (40 psig) requires 4.1 bar (60 psig) and
21.9 Nm
3
/h (13 scfm) air consumption.
Flow rates indicated on chart were determined by pumping water. For optimum life and performance, pumps
should be specified so that daily operation parameters will fall in the center of the pump's performance curve.
Caution: Do not exceed 8.6 bar (125 psig) air supply pressure.
P2 PLASTIC
TPE-FITTED
Ship Weights……...Polypropylene 8 kg (75 lb)
PVDF 10 kg (23 lb)
Air Inlet……………………..……….6 mm (1/4")
Inlet…...…………………...…………25 mm (1")
Outlet………………...………………25 mm (1")
Suction Lift……………………...5.5 m Dry (28')
8.8 m Wet (29')
Disp. per Stroke
1
……...…....0.39 L (0.104 gal)
Max. Flow Rate……………..140 lpm (37 gpm)
Max. Size Solids…………………3.2 mm (1/8")
1
Displacement per stroke was calculated at 4.8
bar (70 psig) air inlet pressure against a 2.1 bar
(30 psig) head pressure.
Example:
To pump 68 lpm (18 gpm)
against a discharge pressure head of
2.7 bar (40 psig) requires 4.1 bar (60 psig)
and 18.6 Nm
3
/h (11 scfm) air consumption.
Flow rates indicated on chart were determined by pumping water. For optimum life and performance, pumps
should be specified so that daily operation parameters will fall in the center of the pump's performance curve.
Caution: Do not exceed 8.6 bar (125 psig) air supply pressure.
DIMENSIONAL DRAWING
PERFORMANCE
