WIKA F1201, Руководство по эксплуатации, Страница: 13 / 40

WIKA operating instructions, model F1201
EN
14505091.01 08/2021 EN/DE
13




5. Commissioning, operation
5.4 Installation of the compression force transducer
■
Place the compression force transduc-
er with its underside on the contact
surface of the measuring object.
■
Optionally, the compression force
transducer can also be fastened to
the contact surface of the test object
with suitable adhesive.
■
Load the compression force transducer
.

Compression force transducers

Support surface
5.3 Electrical connection
To prevent interferences from coupling into the system, observe the following
information:
■
A shielded, low-capacitance measuring cable is attached to the force transducer.
■
A cable amplifier can be fitted optionally.
■
Ground the shield of the measuring cable.
■
Avoid stray fields of transformers, motors and contactors.
■
When using extensions, only shielded and low-capacitance cables should be used.
The permitted maximum and minimum lengths of cable are defined in ISO 11898-2.
Care should be taken also to ensure a high-quality connection of the shielding.
■
Do not install measuring cables in parallel to 3-phase-current cables and control
cables.
■
Transducers, amplifiers and processing or display units must not be grounded
several times.
The pin assignments of the cable and the cable amplifier (fitted optionally) can be found
on the product label.