16
WIKA operating instructions model A2G-200
20210728.01 10/2021 EN/DE
EN
Setting of the DC 2 … 10 V output:
■
Install the jumper on the pins for the DC 0 … 10 V output for the corresponding
measurand.
■
Select the DC 2 … 10 V output via the operation of the LC display in the configuration
menu (see chapter 5.4.3 “Outputs”).
To prevent access to the configuration menu after the installation has been completed, a
jumper must also be installed on the pins for the LC display lock.
5.4 Operation
In order to access the
SET UP
menu, keep the screen pressed for three seconds.
If the jumper for the LC display lock has been installed, this must first be removed before
operation.
5.4.1 Navigation using the menu
Menu navigation
Return to the previous menu without making any changes.
Accept changes and return to the previous menu.
Swipe your finger vertically up or down to navigate between modes.
Swipe your finger horizontally to the left or right to navigate between parameters.
In the main menu, the display modes, the backlighting and also the outputs can be set.
5. Commissioning, operation
CO
2
r. h.
T
DC 0 … 10 V
4 … 20 mA
Setting of the output signal
DC 0 … 10 V output
4 … 20 mA output
Mixed outputs
CO
2
r. h.
T
DC 0 … 10 V
4 … 20 mA
CO
2
r. h.
T
DC 0 … 10 V
4 … 20 mA