Operation manual
Inverta Puls IP6-2 ACT
Page 11 of 20
4.2.1 Manual wire inching & Gas testing
(Not available if MMA/TIG selected)
Manual wire inch mode is activated by pressing the Mode button for 2sec.
In wire speed window is possible to adjust the speed for manual feed.
Feeding is activated by pressing the trigger button.
If the Mode button is pressed again, the Gas test function is active. Gas
valve is activated by pressing the trigger button.
4.2.2 Welding mode selection
(Not available if MMA/TIG selected)
- Two cycle mode
- four cycle mode
4.2.3 Welding process selection
- Standard MIG/MAG process
- Pulsed MIG/MAG Process
- MIG/MAG Double Pulse
- MMA welding process
-TIG welding with Lift Arc ignition
4.2.4 Filler wire material selection
(Not available if MMA/TIG selected)
Fe ACT
- Standard, not alloyed steel, shielding gas: 82%Ar + 18%CO
2
FeSg2
- Standard, not alloyed steel, shielding gas: 82%Ar + 18%CO
2
AlMg5
- Al 5% magnesium, shielding gas: 100%Ar
AlSi5
- Al 5% silicium, shielding gas: 100%Ar
CuSi3
- Copper silicium wire, shielding gas: 100%Ar
CuAl8
- Copper aluminum wire, shielding gas: 100%Ar
4.2.5 Filler wire diameter selection
(Not available if MMA/TIG selected)
0,8mm
1,0mm
1,2mm
