widos 4000 WM, Перевод инструкций по эксплуатации

Страница: 45 / 87

Kunststoffschweißtechnik
Foundation: 2207, 2208 DIN 16932 German association for welding
Use for:
4000
1 bar on manometer:
55
N
PE 80
The value for heating element temperature is between 200° C - 220° C.
The
smaller
the pipe wall the
higher
the temperature.
PE 100
The standard value for heating element temperature is 220° C.
Increase the change-over time and the welding pressure time at PE 100 as fast as possible !
time to
change- reach full
over welding cool-down time
0,15 (PE)
time pressure
pressure in
T
desired temperature
time
pipe pipe SDR bead-up circular heat-up max. time welding cool-
diameter wall pressure bead time change- to reach pressure down
OD (s) [bar] min. [s] over welding [bar] time
[mm] [mm] [mm] time pressure [min]
[s] [s]

in welding area
Table for PE
bead-up heat-up
Additional to the given bead-up force and to the welding force the moving force of the support must be added !
welding area
P (N/mm²)
250
6,2 41 13 1,0 62 6 6 13 9
250
7,7 33 16 1,5 77 6 6 16 11
250
9,6 26 20 1,5 96 7 7 20 13
250
11,9 21,0 25 1,5 119 8 8 25 16
250
14,2 17,6 29 2,0 142 9 9 29 19
250
14,8 17 30 2,0 148 9 9 30 19
250
18,4 13,6 37 2,0 184 10 11 37 23
250
22,7 11 45 2,5 227 11 13 45 28
250
27,9 9,0 54 3,0 279 13 15 54 34
250
34,2 7,4 64 3,0 342 15 18 64 42
280
6,9 41 17 1,0 69 6 6 17 10
280
8,6 33 20 1,5 86 7 7 20 12
280
10,7 26 25 1,5 107 7 7 25 14
280
13,4 21,0 31 2,0 134 8 9 31 18
280
15,9 17,6 36 2,0 159 9 10 36 20
280
16,6 17 38 2,0 166 9 10 38 21
280
20,6 13,6 46 2,5 206 10 12 46 26
280
25,4 11 56 2,5 254 12 14 56 31
280
31,3 9,0 67 3,0 313 14 16 67 38
280
38,3 7,4 80 3,5 383 16 20 80 47
20.08.2014 Working instructions WIDOS 4000 WM Page 40 / 6 of 68