Widinovations wicllaminator L300, Руководство пользователя

Страница: 28 / 38

widinovations Confidential
©
28
10.
Using the longitudinal cutting blades.
Your widlaminator L300 machine comes equipped with a set of longitudinal cutting blades, which can be
adjusted to cut the laminated material. Use these with extreme caution as they are very sharp. After placing them
and during work you can adjust their general placement.
11.
For works with heated lamination.
a. The programed temperature is shown on the left side of the display.
b. At its right is the current temperature.
c. To change the programmed temperature, press the Hot/ Cold button.
is on you can then adjust the temperature pressing the arrow keys
▲ ▼
to increase or lower
When the equipment is in cold lamination mod
shown on the display.
NOTE
The adequate temperature varies according to the type and thickness of laminate used. Contact your supplier
for the correct temperature to laminate any specific material. If the temperature is too high or too low it will
affect the effectiveness of lamination, compromising the final result.
WORK WITHOUT LONGITUDINAL BLADES WORK WITH LONGITUDINAL BLADES