Widinovations wicllaminator L300, Руководство пользователя

Страница: 29 / 38

widinovations Confidential
©
29
5.2.
Turning ON the equipment and beginning work
1.
Ensure that the machine and compressor are connected to an energy outlet.
2. Turn on the compressor, by pulling up the red button, and allow it to fill the deposit before beginning
work.
3. Turn on the machine.
4. Load the material into the lamination axis.
5. Place an empty tube on the waste collection axis.
6. Unroll the laminate, separating the waste paper backing and fix it to the waste collecting axis.
7. Place an empty tube into the laminated material collection axis.
8. Place the material to laminate on its designated axis.
9. Rotate the upper roll control handle upwards.
10. Remove the yellow support hooks from the upper roll.
11. Unroll the material to laminate, passing it under the upper roll and fixing it to the laminated material axis.
12. Pass the laminate through the same path and fix it to the same spot on the laminated material axis.
13. Adjust the axis tension to create some tension but not excessive, the rolls should move in a smooth
continuous fashion.
14. For cold lamination
15. For hot lamination
a.
meaning the desired temperature has been reached.
16. Begin work at the lowest speed, adjusting it with the
+
and
-
buttons.
17. Using the control handle, move the upper roll to its lowest position.
18. Begin work, controlling it with the pedal.
19. Using the pedal and at the lowest speed slowly advance the material to be laminated and the laminate
until both can be securely attached to the laminated material collection axis. Once this is done the
lamination may begin.
20. If the work is proceeding in a stable manner, put the equipment on automatic mode by pressing the
button. Oversee the work and intervene if any problem or fault occurs.
5.3.
Turning OFF the equipment
1.
2. Collect the materials from their corresponding axes.
3. Replace the yellow support hooks, in the inverse order they were removed.
4. switch to the OFF position.
5. Turn off the compressor by pushing the power button down.