WIA MC114-0, Руководство оператора

Страница: 22 / 40

Weldarc 200 AC/DC | Operator Manual | Model No MC114-2
23 22
5 Setting
From the setting menu, general machine
parameters can be adjusted by rotating the
SELECT knob to highlight the parameter.
Press ENTER (right button) to activate
the adjustment.
Make adjustment and then press OK
(right button).
Continue to select parameter or press ESC
(Left button) to return to start.
5.1 Brightness
Use this menu to change the LCD
brightness.Rotate SELECT to adjust
brightness level.
5.2 Language
This menu has no options for now.
5.3 Memory Reset
Use this setting to clear all the stored
memory.
5.4 Information
The information menu provides detail of the
software version. This information may be
useful during machine repair or service.
6 INSTALLATION
Connection to Electrical Mains
Power Supply
The Weldarc 200 AC/DC is fitted with a
15 Amp plug and socket, recognisable by
a wide Earth pin. Power Supply authorities
require that equipment fitted with a 15 Amp
plug shall ONLY be connected to a 240 Volt,
15 Amp power point. DO NOT modify
the plug.
The minimum capacity of the main power
supply wiring and power outlet supplying
a welder is selected according to the
Effective Primary Current of the equipment.
Refer to Section 4.
The minimum recommended main power
supply circuit breaker rating for Weldarc
inverter are listed in Section 4.
The current rating of the mains cable
depends on cable size and method of
installation. Refer to AS/NZS 3008.1,
Table 9.
If it becomes necessary to replace the
mains flexible supply cable, use only cable
with correct current rating. See Section 4.
If it is necessary to use an extension power
supply cable, ensure that it is rated as per
Section 4. Voltage drop which will occur
over long lengths of cable will reduce the
quality of welds and the maximum welding
current available from the equipment.
As noted previously, it is not recommended
that the Weldarc inverter be powered from
small engine-driven generator sets unless
they have adequate voltage regulation. Poor
regulation results in peaks of supply voltage
which can occur with some equipment
of this type. Excessive voltage peaks can
damage the circuits of the welder. Must
have the recommended minimum capacity
and incorporate output voltage regulation.
Knob
Enter
DC TIG
DC TIG
Knob
Enter
AC TIG
Knob
Enter
Pulse AC TIG
Knob
Enter
Pulse DC TIG
Knob
Enter
Stick
Knob
Enter
Setting
+ +
- -
+ +
- -
Press any key or wait seconds to enter.
0 1
Setting
Enter ESC
Knob
Version
Brightness
Reset