White Knight B96M8W, Инструкция по эксплуатации

Страница: 7 / 16

DRYER INSTALLATION
Position the tumble dryer so that the plug remains accessible after installation. Do not block the vents at the front,
rear or base of the dryer, as this will impair the working of the machine. This appliance must not be installed
behind a lockable door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer.
The tumble dryer requires a minimum width of 600mm in order to be installed. If a waste pipe and trap are behind
the appliance, they must not obstruct the air inlet at the back of the dryer.
If the waste pipe is used by the dryer and a washing machine then its diameter must be large enough to contain
both hoses - 1.5" bore (38mm) minimum.
If the floor is uneven the machine will need to be leveled by adjusting the feet of the machine. These can be twisted
to raise and lower the appliance.
CAUTION:
Check that the heat exchanger is installed and the exchanger cover is locked in place.
FILTER INSTALLATION
LOAD PREPARATION
Check care labels inside the garments to ensure that they are suitable for the appliance:
NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM DUE TO THE RISK
OF FIRE.
Push the filter into its operating position as shown in the diagram. Ensure
that the arrow on the top of the filter is pointing towards you. Remove any
dust by wiping the drum and door with a damp cloth. Any initial smell of
burning will be caused by dust on the heater and will quickly disappear.
Suitable for tumble drying
Tumble dry using full heat
Tumble dry using half heat
Do not tumble dry