WhitakerAudio JC Whitaker 20 W Stereo Integrated Audio Amplifier, Руководство пользователя

Страница: 106 / 196

106
WhitakerAudio
– Prepare a 27-inch long #18, black wire. Attach a spade terminal to one end. Connect to the
#4 terminal on the right channel PWB barrier strip (TB3). Bend the barrel up to near
vertical and orient the spade terminal to face the front of the chassis.
– Feed the free end of the black wire to the rectifier PWB through the cable clamps at the
rear of the chassis.
– Prepare two hookup wires as follows: #18 green, 7 inches, and #18 brown, 7 inches. Twist
the wires together.
– Install a connector on the green #18 wire and attach to the 6VH1 post on the left channel
PWB.
– Install a connector on the brown #18 wire and attach to the 6VH2 post on the left channel
PWB.
– Route the green/brown twisted pair to the rectifier PWB. Combine the two green wires
and install a connector. Attach to the 6VH1 post on the rectifier PWB.
– Combine the two brown wires and install a connector. Attach to the 6VH2 post on the
rectifier PWB.
– Attach a spade terminal to the free end of the slate wire. Connect to the #3 terminal on the
left channel PWB barrier strip (TB4). Bend the barrel up slightly and orient the spade
terminal to face the front of the chassis.
– Cut a 22-inch long #22 red 600 V wire. Combine this wire with the free end of the red wire
from the right channel PWB into a single spade terminal. Crimp.
– Attach the red wires to the #1 terminal on the left channel PWB barrier strip (TB4). Bend
the barrel up slightly and orient the spade terminal to face the front of the chassis.
– Attach a quick-disconnect terminal to the free end of the red wire. Route to the rear of the
chassis using the available cable clamp. This wire will connect to the power management
board.
– Cut a 10-inch long #22 white wire. Attach quick-disconnect terminals to each end of the
wire. Attach one terminal to the BIAS post on the rectifier PWB. Attach the other end of
the white wire to the BIAS post on the left channel PWB.