WhisperKool WK 1600, Руководство пользователя

Страница: 11 / 28

-9-
Placement of Unit
Slide the unit from the outside wall into
your wine cellar with the outer flange
flush to the outside wall. Secure the
flange to the wall through the predrilled
holes. The screws should penetrate the
studs as well as the upper and lower
supports to provide adequate support
for the WhisperKOOL System (see
illustration). Seal all cracks and gaps
around the WhisperKOOL unit to prevent
air leakage. If you use molding, it should
be attached to the walls, never to the
WhisperKOOL unit itself.
Slide unit, outside-in, into your
cellar, and secure all screws firmly
to the studs and supports.
Attach the PDT mounting bracket.
Attach the PDT to the mounting bracket.
Wall Stud
Two-by-Four Upper Support
Wall Stud
2” x 4”
Lower Support
Electrical Outlets
Drain line
Installing Thermostat
Attach the thermostat to the front of the
unit using the mounting bracket. Make
sure the black male plastic plug from the
unit is securely fitted into the female plug
located on the circuit board of the
thermostat. To complete the installation,
insert the small black screws into each
side of the thermostat PDT/PDT Jr.
securing it to the mounting bracket.
Electrical Outlet
The unit is equipped with two electrical
outlets, one for installation inside the
cellar and the other for installation
outside the cellar. The outlet on the inside
is covered and has been secured with
screws. Regardless of which side is
utilized, the other outlet must then be
covered in order to avoid live electrical
charge.
Installation