Step Two: Leg Assembly
The legs are contained in the longest box labeled Box #5.
There are two left legs and two right legs.
Use the hardware contained in the “Frame Assembly Kit” pack.
1.
Note “Left” and “Right” labels on the legs and on the frame.
Position a leg into the appropriate corner; insert the
3-1/4" bolt (B)
and tighten securely the flange nut.
The nuts should be on the outside of the frame. Repeat this on all four legs.
Note:
If placing the swing indoors (with low ceiling clearance), insert and fasten two of the legs,
lift frame upright. Then insert and fasten the remaining legs.
2.
LIFT FRAME and place right side up on the prepared site location.
Check, using a level, to be sure each section of the upper frame is level.
Note: DO NOT anchor the legs to the prepared surface at this point.
Anchoring is one of the final installation steps.
PA G E
E I G H T