TROUBLESHOOTING
35
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
Off-taste, odor, or gray
color in the ice or water
Newly installed refrigerator requires
fl
ush of water system.
Flush the water system. See the “Water and Ice Dispensers”
section for water system
fl
ushing instructions.
Recently installed or replaced
plumbing connections. New
plumbing connections can cause
discolored or off-
fl
avored ice and
water.
Discard ice and wash the ice storage bin. Flush the water system
with 3 gal. (12 L) of water. Allow 24 hours for the ice maker to
make new ice and discard the
fi
rst 3 batches of ice produced.
Using a water supply connection type
other than recommended
It is recommended to use copper tubing or Whirlpool
®
supply
line, Part Number 8212547RP. See the “Connect the Water
Supply” section.
The ice has been stored too long.
Discard ice and wash ice storage bin. Allow 24 hours for ice
maker to make new ice.
The water has been stored too long.
Dispense at least 1 qt (1 L) of water per week to maintain a fresh
supply.
Odor from stored food has
transferred to the ice.
Use airtight, moisture-proof packaging to store food.
There are minerals (such as sulfur)
in the water.
A water
fi
lter may need to be installed to remove the minerals.
There is a water
fi
lter installed on the
refrigerator.
Gray or dark discoloration in ice may indicate that the water
fi
ltration system needs additional
fl
ushing. Flush the water
system after installing and before using a new water
fi
lter. See
the “Water and Ice Dispensers” section for water
fi
lter
fl
ushing
instructions.
The water
fi
lter needs to be replaced. Replace the disposable water
fi
lter at least every 6 months or
when indicated. See “Water Filtration System.”
The water and ice
dispenser will not
operate properly.
The refrigerator is not connected to
a water supply or the water supply
shut-off valve is not turned on.
Connect the refrigerator to the water supply, and turn the water
shut-off valve to fully open.
There is a kink in the water source
line.
A kink in the water line can reduce water
fl
ow from the water
dispenser and result in hollow or irregular-shaped ice. Straighten
the water source line.
The refrigerator has just been
installed.
Flush and
fi
ll the water system. See the “Water and Ice
Dispensers” section.
The water pressure to the house is
not at or above 35 psi (241 kPa).
The water pressure to the house determines the
fl
ow from the
dispenser. See the “Water Supply Requirements” section.
A reverse osmosis water
fi
ltration
system is connected to the cold
water supply.
A reverse osmosis water
fi
ltration system can decrease water
pressure. See the “Water Supply Requirements” section.
The water
fi
lter may be clogged.
Remove the water
fi
lter and operate dispenser. If water
fl
ow
increases, your
fi
lter is clogged and needs to be replaced.
See the “Water Filtration System” section.
The water
fi
lter is installed incorrectly. Remove the water
fi
lter and reinstall. See the “Water Filtration
System” section.
The refrigerator door or freezer
drawer is not closed completely.
Close the door or drawer
fi
rmly. If it does not close completely,
see “The doors will not close completely” section.
The refrigerator doors were recently
removed.
Make sure the water dispenser wire/tube assembly has been
properly reconnected at the top of the refrigerator door. See
“Remove and Replace Refrigerator Doors” section.
Ice is clogged in the ice storage bin
or ice is blocking the ice delivery
chute.
Remove the ice clogging the storage bin and delivery chute,
using a plastic utensil if necessary. Clean the ice delivery chute
and the bottom of the ice storage bin using a warm, damp cloth,
then dry both thoroughly. To avoid clogging and to maintain a
fresh supply of ice, empty the storage bin and clean both the
storage bin and delivery chute every 2 weeks.
Содержание WRX735SDHV
Страница 124: ...124 NOTES ...