be cleaned once per week. Please use cleaning brush to clean the rough and fine filter, and reinstall
into the dishwasher. The dishwasher should not be used without filter or with improper filter.
Otherwise, the equipment may be damaged, and the washing performance may be reduced.
1. Do not operate the dishwasher without filter.
2. Do not touch the filter during washing cycle, which may cause filter deformation and poor washing
performance.
Cleaning the Sprayer
Sprayer should be cleaned periodically, as the substances in tap water may block the sprayer holes and
spinning axle. Use mild soap water to rinse the sprayer and brush the sprayer holes gently. Install the
sprayer back to the dishwasher.
Pull the sprayer upward
Use fine tool to clean the sprayer
holes
WARNING!
If the limescale accumulate excessively, add more vinegar or anti-scaling agent with over 200ml vinegar
and anti-scaling agent (between 75 and 150g). After cleaning, use a towel or brush to clean the heating
plate.
Notes
14
15
EN
WARNING!
Never use a spray cleaner to clean the door panel for it could damage the door lock and electrical
component. Do not use abrasive agent. Stainless steel surface may be badly scratched by the extensive
or repeated use of abrasives.
Remove Limescale
In areas with harder water quality, white limescale may accumulate on the tub and heating plate of the
dishwasher. Limescale will impact heating effect of the heating panel. Thus, the heating panel should
be cleaned periodically.
R
emove the filter and place it into the rack.
2. Start the “Self-Clean” program (no other tableware should be placed in the rack). After an operation of
2-10 minutes, press "Pause" and open the dishwasher.
3. Add amount 100ml vinegar or 50g anti-scaling agent and resume the washing program.
4. When the program ends, you may take a towel and wipe away the thin film on the heating plate gently. If
there is any vinegar smell or anti-scaling agent residue in the dishwasher, you can run a "Self-Clean"
washing program with the "Sanitize" option for removal without any tableware or detergent placed in
the dishwasher.
1
.
Cleaning the Dishwasher
Remove the Plug
Before cleaning or performing maintenance, always remove the plug from the socket.
No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products.
Use only a cloth and warm soapy water. To remove spots or stains from the surface of the interior, use a
cloth dampened with water and a little white vinegar, or a cleaning product made speci
fi
cally for
dishwasher.
-
To clean the control panel, use wet cloth wipe it gently and let it dry thoroughly. Use good
polishing products
to clean the exterior.
- Use tools such as a cotton swab to remove water droplets or food stuck in the door edge and the plastic strip.
- Do not use any sharp objects, steel wool or fierce detergent to clean any part of the dishwasher.
Anti-freezing protection:
If the dishwasher is placed under 0°C environment , you are suggested to find customer service for
taking following measures:
1. Cut off the dishwasher power.
2. Close water supply equipment and break connection between the inlet hose and faucet.
3. Discharge remaining water from inlet hose and water valve (catch the water with a plate).
4. Re-connect the inlet hose and faucet.
5. Take out the filter from the tub and dry the water cup with sponge.
Attention:
The installation of the pipes and electrical equipments should be done by professionals.
Electrical Shock Hazard! Disconnect
electrical power before installing
dishwasher.
Failure to do so can result in death or
electrical shock.
Warning!
Advice and Tips
After Every Wash
-
After e
very
wash, please cut off the power and open the door to prevent dampness and
the generation of
odor
.
Dishes will also dry better.
- Please use dry clean towels to clean the door and the interior of the dishwasher after every wash to remove
water spots and water droplets.
