1. Draining hose
2. Inlet hose
3. Power cord
Installation of Draining Hose
1. The opening of draining hose
2. Insert the “double wire clamp” into the draining hose
3. Put the draining hose into the installation opening
and buckle the “double wire clamp” inward.
2
. INSTALLATION INSTRUCTION
1
2
3
1
2
3
3
．
OPERATION INSTRUCTION
Control Panel
Dishwasher Features
Front View
1. Air Inlet Inflow
2. Spray Arms
Cutlery Basket
3.
4. Dish Basket
1
2
3
4
1
Power Dry: This function can be used with all programs (Except Pre-wash), for which it will
automatically enter into high-temperature sterilizing washing mode and extend the drying duration
for an upgraded drying performance. The indicator will be available when the “Power Dry” function
is selected.
1.
2.
3.
5.
6.
2
3
4
5
6
Start Delay: you can delay start time of any cycle automatically from 1 to 24hours. After the
Start/Pause button: the dishwasher will start or pause the expected washing cycle. After the
dishwasher starts, press the button for 3 seconds, the dishwasher drains.
7.
Detergent box
5.
5
7
4.
Sanitize: This function can be used with all programs (Except Pre-wash), for which it will
automatically enter into high-temperature sterilizing washing mode after programed washing ends.
Sanitize cannot be selected independently. The indicator will be available when the
“Sanitize” function is selected.
6
7
Program button: Press the button to scroll through the wash cycles. Press the “P” button, you can
select P1-P7 programs that are show
n
on the panle, or select program shortcut button "1h Wash
& Dry" or "Self-Clean".
Display: After program selection, time and
program
indicators will be shown alternatively.
Pipe Opening Installation
This dishwasher should be installed before use. Please do not use the machine before inlet hose
and draining hose are installed!
Install pipes and power cord at the corresponding installation openings.
dishwasher starts, you can press the button for 3 seconds to active the “Child Lock”. The "Child Lock"
function will block the control panel, and “Lo” will be displayed. Any key press on the panel will
cause a beep sound. To deactivate the "Child Lock", you can press the “Start Delay” button for 3
seconds again.
EN
WARNING!
Do not use water with higher than 35 degree. It would affect the actual execution time and shorten the life of
the pipe. If the water pipe is new or has not been used for an extended period of time, let water run before
using it. A blocked water inlet may cause damage to the appliance.
inlet hose
connected with
other water pipe
1. Turn off the water supply before installation.
2. Drill a hole about 50mm in diameter and install the pipe holder on the desk.
3. Set the dishwasher on the desk and connect it to inlet hose and draining hose* properly. Pass the other end of the
inlet hose through the pipe holder and connect it with the three-way valve.
4. Ensure that the three-way valve is connected with a fixed cold water supply.
5. Turn on the water supply again to complete the installation.
connected with
dishwasher's inlet hose
connected to
water source
three-way valve
Installation of Inlet Hose
pipe holder
three-way
valve
Installation Steps:
Please make sure the drain hose is not squeezed or lifted during washing. The dishwasher might not work
properly if the drain hose is hung 25cm higher than the dishwasher drain outlet.
