10
CLEANING AND MAINTENANCE
Make sure that the oven has cooled down before
carrying out any maintenance or cleaning.
Do not use steam cleaners.
Wear protective gloves.
Do not use wire wool, abrasive scourers or abrasive/
corrosive cleaning agents, as these could damage the
surfaces of the appliance.
The oven must be disconnected from the mains
before carrying out any kind of maintenance work.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If
any of these products inadvertently comes into
contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues To
dry any condensation that has formed as a result
of cooking foods with a high water content, let the
oven to cool completely and then wipe it with a
cloth or sponge.
• Activate the “Smart Clean” function for optimum
cleaning of the internal surfaces.
• Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
The glass tray is dishproof safe.
TROUBLESHOOTING
Problem
Possible cause
Solution
The oven is not working.
Power cut.
Disconnection from the mains.
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
The display shows the letter “F” followed
by a number.
Software fault.
Turn off the oven and restart it to see if the problem
persists. Try to perform the “FACTORY RESET” from,
selectable from “SETTINGS”. Contact you nearest Client
After-sales Service Centre and state the number following
the letter “F”.
The oven does not heat up.
When “DEMO” is “On” all
commands are active and menus
available but the oven doesn’t
heat up.
Access “DEMO” from “SETTINGS” and select “Off”.
PRODUCT FICHE
WWW
The product fiche with energy data of this
appliance can be downloaded from Whirlpool
website
docs . whirlpool . eu
HOW TO OBTAIN THE USE AND CARE GUIDE
>
WWW
Download the Use and Care Guide
from our website
docs . whirlpool . eu
(you
can use this QR Code), specifying the
product’s commercial code.
> Alternatively, contact our Client After-sales Service.
CONTACTING OUR AFTER-SALES SERVICE
You can find our contact details
in the warranty manual. When
contacting our Client After-sales
Service, please state the codes
provided on your product’s
identification plate.
XXX/XXX
XXXXXXXXXXXX
XXXXXXXXXXXX
400011197627
Printed in Italy
