17
8.
Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
B
A
C
D
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
9.
Replace with correct Natural gas orifice spud. See the charts
in Step 4.
A
B
C
A. Burner cap
B. Electrode
C. Burner base
10.
Place Propane gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
11.
Replace burner base and tighten the two screws.
IMPORTANT:
Be sure that the electrode aligns with the notch
or hole in the burner base. The igniter electrode is ceramic
and could break during installation of the burner base.
12.
Replace burner cap.
13.
Repeat steps 1-11 for the remaining burners.
14.
Open shut-off valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
REMEMBER:
Once you have completed converting all of the
cooktop burners, test the appliance for leaks by brushing on
an approved noncorrosive leak-detection solution. If bubbles
appear, a leak is indicated. Correct any leaks found.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
15.
Plug cooktop into grounded 3 prong outlet or reconnect
power.
Lighting the Electronic Igniters
The cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is pushed in and turned to
Lite, the system creates a spark to light the burner. This sparking
continues until the control knob is turned to the desired setting.
To Check Operation of the Cooktop Burners:
1.
Push in and turn knobs to Lite. The cooktop burner flame
should light within 4 seconds. The first time a burner is lit, it
may take longer than 4 seconds to light because of air in the
gas line. Do not leave the knob in the Lite position after burner
lights.
O
F
F
M
E
D
L
O
2.
If burners do not light properly, turn the control knob to Off.
Make sure the burner cap is in the proper position.
3.
Check that the power supply cord is plugged in and circuit
breaker has been tripped or household fuse has not blown.
4.
Check that the shut-off valve is in the on position.
5.
Check burner operation again.
If
one
or
all
of
the
burners
do
not
light
at
this
point,
see
the
"
Online
Ordering
Information
"
section
in
the
Quick
Start
Guide.
Содержание GLT3057
Страница 38: ...38 Remarques ...
Страница 39: ...39 Remarques ...