Whirlpool GLT3057, Руководство пользователя

Страница: 10 / 40

10
4. Attach brackets to cooktop base bottom with bracket
attachment screws using the bracket mounting holes selected
in Step 2.
5. Rotate brackets so they do not extend beyond edge of
cooktop base.
6. Tighten screws just enough to hold brackets in place when
cooktop is put in cutout.
7. Using two or more people, turn the cooktop right side up and
place in cutout.
NOTE:
Make sure that the front edge of the cooktop is parallel
to the front edge of the countertop. If repositioning is needed,
lift entire cooktop up from cutout to avoid scratching the
countertop.
8. Loosen the screws and rotate the brackets so that they are
perpendicular to the edge of the cooktop base and extend
beyond its edge. Securely tighten screws.
Installing Brackets After Placing Cooktop in
Cutout
1. Using two or more people, place cooktop right side up into the
cutout.
NOTE: Make sure that the front edge of the cooktop is parallel
to the front edge of the countertop. If repositioning is needed,
lift entire cooktop up from cutout to avoid scratching the
countertop.
2.
Remove the attachment screws for the selected bracket
locations from the bottom of the cooktop base.
3.
Select bracket mounting holes that will allow the bracket to
extend far enough out from the cooktop for the installation of
2
1
/
2
" (6.4 cm) clamping screws.
D
A. Cooktop
B. Cooktop base
C. Attachment screw
D. Clamping bracket (extends far enough beyond
cooktop base to allow installation of clamping
screws)
E. 2
1
/
2
" (6.4 cm) clamping screw (to be installed in
the “Attach Cooktop to Countertop” section)
F. Countertop
G. Foam seal
4. Attach brackets to cooktop base bottom with bracket
attachment screws using the bracket mounting holes selected
in Step 3. Securely tighten screws.
Make Gas Connection
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include: licensed heating
personnel, authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
To Assemble Pressure Regulator:
1.
Using two or more people, stand the cooktop on its side or
back.
2. Connect the flexible stainless steel connector to the pressure
regulator using a 1/2" (13 mm) male pipe thread adapter and
nipple. A combination of pipe fittings must be used to connect
the cooktop to the existing gas line. Shown following is a
typical connection. Your connection may be different,
according to the supply line type, size, and location.
3. Install the pressure regulator with the arrow pointing up toward
the bottom of the cooktop base and in a position where you
can reach the regulator cap.
B
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Up arrow. Regulator must be installed with
arrow pointing up to cooktop bottom
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause a
gas leak. Do not allow the regulator to turn on the pipe when
tightening fittings.
Use only pipe-joint compound made for use with Natural and
Propane gas.
Do not use TEFLON
®
tape. You will need to determine the fittings
required depending on your installation.