14
Style 2:
The cap does not have a slot and requires a wrench
to be removed.
Remove the access cap by using a wrench, turning the
access cap counterclockwise.
Remove the spring retainer from the cap by pushing against
the flat side of the spring retainer. Look at the spring retainer
to locate the "NAT" or "LP" position. Turn over the spring
retainer so the "LP" is showing on the bottom. Snap the spring
retainer back into the cap. Reinstall the cap onto the regulator.
A
B
C
D
E
A. Access cap
B. Gasket
C. Gas pressure
regulator
D.
LP position
E.
NAT position
4.
Test the gas pressure regulator and gas supply line.
The
regulator
must
be
checked
at
a
minimum
2.5
cm
water
column
above
the
set
pressure.
The
inlet
pressure
to
the
regulator
should
be
as
follows
for
operation
and
checking
the
regulator
setting:
Propane
Gas:
Minimum
pressure:
10"
(25.4
cm)
WCP,
2.49
kPa
(0.36
psi)
Supply
pressure:
14"
(35.56
cm)
WCP,
3.5
kPa
(0.50
psi)
Gas
Supply
Pressure
Testing
Line
pressure
testing
above
1/2
psi
(3.5
kPa)
gauge
14"
(35.5
cm
WCP)
The
cooktop
and
its
individual
shut-off
valve
must
be
disconnected
from
the
gas
supply
piping
system
during
any
pressure
testing
of
that
system
at
test
pressures
in
excess
of
1/2
psi
(3.5
kPa).
Line
pressure
testing
at
1/2
psi
(3.5
kPa)
gauge
14"
(35.5
cm
WCP)
or
lower
The
cooktop
must
be
isolated
from
the
gas
supply
piping
system
by
closing
its
individual
manual
shut-off
valve
during
any
pressure
testing
of
the
gas
supply
piping
system
at
test
pressures
equal
to
or
less
than
1/2
psi
(3.5
kPa).
5.
If they are installed, remove the burner grates.
Use the following chart to match the correct gas orifice spud
with the burner location and model being converted.
Propane Gas Orifice Spud Chart
Burner Rating
Color
Size
5,000 BTUs
Red
0.66 mm
A
A. Size stamp
or color
9,100 BTUs
Yellow 0.88 mm
9,100/11,000 BTUs
Brass
0.93 mm
11,000 BTUs
Blue
1.00 mm
13,000 BTUs
White
1.08 mm
Four Burner Models
Model No.
Right
front
Right
rear
Left
front
Left
rear
SCS3017
SCS3617
Red
Red
Brass
Blue
Brass
Blue
Yellow
Brass
GLT3057
Blue
Red
Blue
Brass
KGCC706
KGCC506
Red
Blue
White
Brass
W3CG3014
ICS333
Red
Brass
Blue
Brass
Five Burner Models
Model No.
Right
front
Right
rear
Center
Left
front
Left
rear
GLT3657
Blue
Red
Brass
Blue
Red
KGCC766
KGCC566
Red
Blue
Brass
White Red
KGCV566
White
Red
Brass
White Red
Burner Locations
B
D
C
E
A
A. Left front
B. Left rear
C. Center
D.
Right rear
E.
Right front
6.
Remove all burner caps and burner bases.
Содержание GLT3057
Страница 38: ...38 Remarques ...
Страница 39: ...39 Remarques ...