Whirlpool GLT3014G, Руководство пользователя

Страница: 20 / 44

2-8
5. Use a nut driver (7 mm) to remove the
existing orifice and replace it with an LP
orifice. Note: A small amount of tape in-
side the nut driver will help hold the orifice
in the nut driver.
6. Replace burner base and tighten the two
screws.
IMPORTANT: The ignitor electrode is ce-
ramic and could break during conversion.
Be sure that the electrode comes through
the hole in the burner base while you tighten
the screws.
Cap
Ignitor Electrode
Burner Base
7. Complete steps 4, 5, and 6 for each burner
on the cooktop.
8. Use the following procedure and leak test
the cooktop:
WARNING: NEVER TEST FOR GAS
LEAKS WITH A MATCH OR OTHER
FLAME.
Use a brush and apply liquid detergent to
all of the gas connections and check them
for leaks. Bubbles around connections will
indicate a leak. If a leak appears, shut off
gas valve controls, tighten the connection,
and recheck the connection again. Clean
all of the detergent solution from the
cooktop.
Electronic Ignition System—
Initial Lighting
Cooktop burners use electronic ignitors in place
of standing pilots. When the cooktop control
knob is pushed in and turned to the "LITE" po-
sition, the system creates a spark to light the
burner. This sparking continues until the con-
trol knob is turned to the desired setting.
9. Check the operation of the cooktop burn-
ers. Push in and turn each control knob to
the “LITE” position. The flame should light
within 4-seconds.
Do not leave the knob
in the “LITE” position after burner lights.
If the burners do not light properly, turn the
control knob to the “OFF” position. Check
that the burner cap is in the proper posi-
tion. Check that the power supply cord is
plugged in and that the circuit breaker, or
house fuse, has not blown. Check that the
gas shutoff valve is in the “ON” position.
Check the operation again. If a burner still
does not light, refer to “Diagnosis &
Troubleshooting” in Section 6.