Whirlpool G0, Руководство пользователя

Страница: 24 / 79

©
Service Competence Center
Operation
Eco Booster
Ind
u
ctio
n
G
0
Eco Booster
This function is available only on coils with 210mm or 240 mm dimension.
Activation is done by touching the special function key after the coil selection. When
the Eco Booster has been activated, the UI has to show on the active coil the letter “E”.
When this mode is entered the appliance output power on that heater exceeds
maximum level P for a limited amount of time (Max_Booster_Time).
After this time the level on that heater is lowered to level 7.
This limitation is set and controlled by IPC. IPC will provide the lower actual power level
to User Interface via WIDE bus, but it will continue to display letter “E”.
The ECO-Booster function can be present or not in each zone depending on the
cooktop configuration.
There is the following restriction:
- It can not be activated simultaneously on two zones managed from the same IPC. If
the user tries to do so, the last touched zone (therefore the active zone) gets the
booster level.
The previous zone set with booster is depowered to a lower power level. Before this
level reduction the “E” will flash 2 times and then go to the new level (to highlight that a
change has taken place).