Whirlpool Cabrio WTW8800YC, Инструкция по использованию и уходу

Страница: 13 / 40

13
First try the solutions suggested here or visit our website at www.whirlpool.com/help
for assistance and to possibly avoid a service call.
If you experience
Possible Causes Solution
Feet may not be in contact with the
floor and locked.
Front and rear feet must be in firm contact with floor, and washer
must be level to operate properly. Jam nuts must be tight
against the bottom of the cabinet.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See “Level the Washer” in the Installation Instructions.
Load could be unbalanced.
Load garments in loose heaps evenly around the washplate.
Do not load garments directly over the center of the washplate.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Avoid washing single items. Balance a single item such as a
rug or jeans jacket with a few extra items. If the dial is flashing,
redistribute the load, close the lid, and press START/PAUSE.
Use Bulky Items cycle for oversized, non-absorbent items
such as comforters or poly-filled jackets. Other items are
not appropriate for Bulky Items cycle. See “Cycle Guide.”
Item or load not suitable for selected cycle. See “Cycle Guide”
and “Using Your Washer.”
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
Washer not level. Water may splash off basket if washer is not level.
Fill hoses not attached tightly. Tighten fill-hose connection.
Make sure all four fill hose flat washers are properly seated.
Drain hose connection Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Check household plumbing for leaks
or clogged sink or drain.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Fill hose washers
Noises
– For normal operating sounds, go to www.whirlpool.com/help.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
Objects caught in washer
drain system.
Clicking or metallic
noises
Gurgling or humming It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as final amounts of
water are removed during the spin/drain cycles.
Washer may be draining water.
Water Leaks
Check the following for
proper installation:
Do not place tape over drain opening.
An unbalanced load can cause basket to be out of alignment
and cause water to splash off tub. See “Using Your Washer”
for loading instructions.
Washer not loaded as
recommended.
TROUBLESHOOTING
Vibration, rocking, or
“walking”
Not enough water
in washer
Load not completely covered
in water.
This is normal operation for an HE low-water washer. The load
will not be completely underwater. The washer senses load sizes
and adds correct amount of water for optimal cleaning. See
“What’s New under the Lid.”
IMPORTANT: Do not add more water to washer. Adding water
lifts the garments off the washplate, resulting in less effective
cleaning.
Washer not performing as expected
Washer may not be level.
Vibration or Off-Balance
Vibration during spinning
or washer stopped with
all dial lights flashing
Humming You may hear the hum of the sensing spins after you have
started the washer. This is normal. Sensing spins will take
several minutes before water is added to the washer.
The washer is sensing the load size.